– Speaker A and B must both be selected on the front panel of the unit for this type of connection to work. If your loudspeakers are equipped with two sets of terminals, then it is possible to connect them in the bi-wire configuration.īi-wiring sends the bass and treble frequencies down separate speaker cables, resulting in a clearer, more focused sound. Note: When using two pairs of speakers, use speakers with a nominal impedance of 8 ohms each. Refer to the Front Panel or Remote Control section of this manual for more information on the Speaker A/B operation.Įither A or B, or both A and B may be selected for use. The Speaker A/B button on the front panel and remote control allows the two sets of speakers to be toggled on and off. The Speaker B connections on the back of the amplifier allow for a second set of speakers to be used (i.e. The diagram below shows how to connect the AXR100D to an active subwoofer via the LFE/Sub input on the subwoofer. The Sub Out is for connecting to the LFE/Sub input of an active subwoofer. Note: Do not connect a non-phono source to the phono input. If your turntable does have a built-in Phono stage or you are using an external version, you should connect to any of the other analogue inputs, as the 'Phono' input may produce an unwanted distortion. This unit has a built-in Phono preamplifier (Phono Stage), so if your turntable does not possess its own Phono Stage, you may connect the record player to the input on the rear of the unit marked 'Phono'. The diagram below shows the basic connection of the AXR100D to a turntable via the Phono input. The diagram below shows the basic connection of the AXR100D to a CD player using the A1 analogue input and a pair of loudspeakers.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |